My guess would be that the initrd file was created with a config to load
the wrong module for your RAID. I would try manually loading modules
from a rescue disk, when you find the right one, put it in your
/etc/modprobe.conf file and then recreate your initrd file.
Louis Garcia wrote:
I installed a minimum fc3 on a PII box. It has an ide boot drive (hda)
and two scsi HD (sda, sdb) in a raid config. The boot loader is in the
MBR of hda. The install goes fine but when it comes to booting up it
hangs right before the grub screen. If I take out the scsi card it boots
fine (except it complains about missing raid discs). This is a Gateway
G6 with an Adaptec aha-2940 UW. Any thought?
Thanks, --Louis
--
cybersource.us
115 Richfield Road
Williamsville, New York 14221
716-553-8525
