Fred Skrotzki wrote:
I don't know what's going on with your system, but I don't think the problem is what you mentioned. I run 2.6.9-1.681_FC3smp with ext3 partitions with no problem.I've even run up2date and using the latest 2.6.9-1.681_FC3 it still panics when booting. Thanks to the lack of ext3 drivers being built in.
Not the greatest distro. If you are lazy, in a hurry and let it automatically configure the drive(s)for you, it of course defaults to ext3. Which then makes your build in FC3 under SMP USELESS..
Or does somebody have it working and know a trick to get around this. I can of course select the non SMP build and it boots fine but then I'm wasting the second processor which we need.
-----Original Message----- From: fedora-list-bounces@xxxxxxxxxx [mailto:fedora-list-bounces@xxxxxxxxxx]On Behalf Of Fred Skrotzki Sent: Wednesday, December 01, 2004 5:49 PM To: fedora-list@xxxxxxxxxx Subject: FC3 ext3 and SMP kernel errors.
Hardware: HP Lp2000r dual 1.0 Ghz procs, 1 Gig ram, Single 36 gig drive.
I just built a clean install (for the third time to be sure) on the above hardware. (FC2 runs perfectly on identical hardware).
Can anybody confirm this?
I'm going to rebuild again using ext2 to get by this problem.
--
------------------------------------------------------------------------
*Gustavo Seabra* <http://www.ksu.edu/chem/personnel/faculty/grad/jvo/ortiz/people_seabra.html> - Graduate Student
E-Mail: seabra@xxxxxxx <mailto:seabra@xxxxxxx>
Phone: (785) 532-6072 Chemistry Department <http://www.ksu.edu/chem/>
Kansas State University <http://www.ksu.edu>
Manhattan, KS 66506-3701
