Carroll wrote: On Tuesday 16 November 2004 02:32 pm, Paul Kopacz wrote: > I have a PCI modem which I have attempted to install into a box with > an ECS P6LX-A+ motherboard. This computer does not seem to detect > this card (as in lspci does not list the card). I have a SCSI > controller, a video card, and an ethernet card in the other 3 PCI > ports on this board. I have tried different slots, even tried > removing the ethernet card entirely to see if there is some sort of > conflict (I can't remove the video card for obvious reasons nor the > SCSI card as I then couldn't boot). The PCI modem is not fried, as > putting it into another computer and running lspci shows: > > 00:0d.0 Communication controller: Lucent Microelectronics LT WinModem (rev 02) > > (Yes I know this is a winmodem, but there are linux drivers). Paul: Start here: http://www.linmodems.org/ -- cmg --------------------------------------------------------------------------------------------------------------- Thanks Carroll, Unfortunately, if that was my problem, I would be a lot better off. I have been able to make this modem work under linux before. However, it is not even being detected by lspci on this particular computer. I don't know if perhaps it is possible that the mb is incompatible with this particular modem card, or if this might be caused by an IRQ conflict (or how such a thing is resolved), or any other random thing. I've tried doing some tests (as mentioned above), but I'm not quite sure what to try next. Paul
