xray, Since you're new to Linux, I believe the simplest way to get the centrino working would be to start the graphical interface. From the main menu, go to System Configuration->Internet Configuration Wizard and select Wireless. You should see the Centrino listed there. Once you see it, just configure it as you need. I'm pretyt sure that will modify your /etc/modprobe.conf to autoload the driver at boot time. Pankaj xray (x-raymail@xxxxxx) wrote: > > Just another wlan ipw2200 problem again. > > I use FC3 and have an Acer Travelmate 4000 with centrino. > To use the wlan i downloaded all needed files and followed every step > (by step) in the INSTALL file. > > First, i have to load the driver manually with ./load witch outputs this > error .... > ( if i dont load them, eth1 is not displayed ) > > [root@xr-mobile ipw2200-0.13]# ./load > No modules unloaded. > FATAL: Module firmware_class not found. > Loaded: ieee80211_crypt ieee80211 ieee80211_crypt_wep ipw2200 > > [ *snip* files in /lib/firmware/ ] > [root@xr-mobile firmware]# ls ip* > ipw2200_boot.fw ipw2200_bss.fw ipw2200_ibss.fw ipw2200_ucode.fw > [ *snip* ] > > > [root@xr-mobile ipw2200-0.13]# iwconfig > lo no wireless extensions. > > eth0 no wireless extensions. > > sit0 no wireless extensions. > > eth1 unassociated ESSID:"Auto" Nickname:"xr-mobile" > Mode:Managed Channel=0 Access Point: 00:00:00:00:00:00 > Bit Rate=0kb/s Tx-Power=20 dBm > RTS thr:off Fragment thr:off > Encryption key:off > Power Management:off > > I´m a linux beginner, so i was very happy that the wireless tools are > already available via yum - dont even think about kernel configuration ;-) > > Any ideas ? > Hope i dont spam around with this problem. > > Regards > > Jens Frieben > > -- > fedora-list mailing list > fedora-list@xxxxxxxxxx > To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list > >
