On Tue, 2004-10-05 at 06:51, Leonard Isham wrote: > > I've checked the routing. > > The line 0.0.0.0 has gateway 192.168.0.1 and genmask 0.0.0.0 > > The routing is fine. > > Check to make sure your netmask is correct and matches the netmask on > the router. While 255.255.0.0 is the default netmask for the address > class it is usually subdivided into smaller subnets. Actually, the default netmask for a 192 address is /24 Class A is 1-127 Class B is 128-191 Class C is 192-223 > > As an example if the router's subnet mask is 255.255.255.0 your IP > address of 192.168.10.35 would not work when routing. But, yes, this is definitely the area to look in to. What is the netmask on the router itself for the interface you are attached to. If you do not have access to the router, you could also adjust your one machine's IP address to have a zero in the third octet instead of the current value of ten. I would also question what the router is providing. The 192.168.x.0 networks are considered private IP addresses and cannot be directly connected to the public Internet. They must pass through some sort of "NAT" or "Network Addressable Translation" device, perhaps the router. In that case, some of the lower end devices may not support the "supernetting" you are doing in the 192 range and you may need to stop changing the third octet to ten and set your netmasks to the more appropriate /24 (255.255.255.0). HTH, --Rob
