Hi all, Just try to mount USB key 256M on my FC2 box. I have kernel modules like usb_storage, sg, vfat, sd_mod, scsi_mod. When plug in I see: scsi2 : SCSI emulation for USB Mass Storage devices Vendor: OTi Model: Flash Disk Rev: 2.00 Type: Direct-Access ANSI SCSI revision: 02 sda: Unit Not Ready, sense: Current : sense = 70 6 ASC=28 ASCQ= 0 Raw sense data:0x70 0x00 0x06 0x00 0x00 0x00 0x00 0x0a 0x00 0x00 0x00 0x00 0x28 0x00 0x00 0x 00 0x00 0x00 sda : READ CAPACITY failed. sda : status=1, message=00, host=0, driver=08 Current sd: sense = 70 6 ASC=28 ASCQ= 0 Raw sense data:0x70 0x00 0x06 0x00 0x00 0x00 0x00 0x0a 0x00 0x00 0x00 0x00 0x28 0x00 0x00 0x 00 0x00 0x00 sda: Write Protect is off sda: Mode Sense: 03 00 00 00 sda: assuming drive cache: write through sda: unknown partition table Attached scsi removable disk sda at scsi3, channel 0, id 0, lun 0 Attached scsi generic sg0 at scsi3, channel 0, id 0, lun 0, type 0 USB Mass Storage device found at 4 usbcore: registered new driver usb-storage USB Mass Storage support registered. --------------------------------------------------------------------- So the command: # mount -t vfat /dev/sda1 /mnt/usbkey gives me the error: mount: /dev/sda1 is not a valid block device But when I try: # mount -t vfat /dev/sda /mnt/usbkey (yes, /dev/sda instead of /dev/sda1) it works ! Any explanations ? Thank you in advance -- Quy NGUYEN DAI http://vnoss.org/forum/
