Apologies.. should've been more specific... Motherboard: IWill KK266-R RAM: 768Mb PC133 HD: Maxtor 15Gb (DiamondMax?) CD: Plextor 16x40x16 CDRW GFX: Diamond Viper V770u NIC: Kingston KNE100 (I think) There are no peripherals connected at all besides a monitor and a network cable. There is only one PCI card in the machine (the NIC), and there is a single HD and single CD drive, both Master on IDE1 and IDE2 respectively. Hope this is enough info. Thanks, Darren > -----Original Message----- > From: fedora-list-bounces@xxxxxxxxxx [mailto:fedora-list- > bounces@xxxxxxxxxx] On Behalf Of Scot L. Harris > Sent: 05 October 2004 15:13 > To: Fedora List > Subject: Re: Fedora Core 2 boot problems > > On Tue, 2004-10-05 at 09:57, Darren Coleman wrote: > > Hi, > > > > I hope someone out there will be able to help, I think I have a somewhat > > unique problem. > > > > I have installed Fedora Core 2 on my system successfully but when I try > to > > boot it after the install I get as far as the Grub loader, and then it > just > > sits there. > > I would help if you listed the mother board type and model you are > using. There have been a few mother boards that have had problems, but > in most if not all cases work arounds or fixes have been found and > published. > > You should also include a list of any additional peripherals that are > connected. There was a recent thread concerning certain USB devices > causing problems. > > > -- > Scot L. Harris > webid@xxxxxxxxxx > > linux: the choice of a GNU generation > (ksh@xxxxxxxxxxx put this on Tshirts in '93) > > -- > fedora-list mailing list > fedora-list@xxxxxxxxxx > To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
