I went through the sensors-detect routine again, accepted all
the defaults and it appears that I may need to install a "driver"
somewhere but "should be inserted" leaves me wondering,
inserted where and how?
- - - - - - - - - - - - - - - - - - - - - - -
Now follows a summary of the probes I have just done.
Just press ENTER to continue:
Driver `adm9240' (should be inserted):
Detects correctly:
* Bus `SMBus PIIX4 adapter at 7000' (Algorithm unavailable)
Busdriver `i2c-piix4', I2C address 0x2d
Chip `Analog Devices ADM9240' (confidence: 7)
- - - - - - - - - - - - -
Apparently the only device detected is an smbus device.
- - - - - - - - - - - - -
Probing for `Analog Devices ADM9240'... Success!
(confidence 7, driver `adm9240')
- - - - - - - - - - - - -
Scanning for ISA only, answering no to the smbus scans produces
the message " Sorry, no chips were detected. "
So I conclude that it's smbus or nothing. With RH-9 I would see
messages relative to the "sensors" at system boot, I don't get
them now.
So do I need to install a "driver" and if so, where and how? I may
still have one on the other hard drive if I knew the file name.
Thank you.
Bob Goodwin Zuni, Virginia
