On Sun, 2004-08-29 at 20:30, Tom Conway wrote: > The issue is definetly network, my server has 2 cards, > 192.168.0.15 > 192.168.0.20 (currently no cable connected) > > > IP ROUTE > 192.168.0.0/24 dev eth1 scope link > 192.168.0.0/24 dev eth1 proto kernel scope link src 192.168.0.20 > 169.254.0.0/16 dev eth1 scope link > 127.0.0.0/8 dev lo scope link > default via 192.168.0.1 dev eth1 > > IP ADDRESS > 1: lo: <LOOPBACK,UP> mtu 16436 qdisc noqueue > link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 > inet 127.0.0.1/8 brd 127.255.255.255 scope host lo > inet6 ::1/128 scope host > valid_lft forever preferred_lft forever > 2: eth0: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast qlen 1000 > link/ether 00:50:8b:d6:33:89 brd ff:ff:ff:ff:ff:ff > inet 192.168.0.15/24 brd 192.168.0.255 scope global eth0 > inet6 fe80::250:8bff:fed6:3389/64 scope link > valid_lft forever preferred_lft forever > 3: eth1: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast qlen 1000 > link/ether 00:50:8b:ae:f5:f0 brd ff:ff:ff:ff:ff:ff > inet 192.168.0.20/24 brd 192.168.0.255 scope global eth1 > inet6 fe80::250:8bff:feae:f5f0/64 scope link > valid_lft forever preferred_lft forever > 4: sit0: <NOARP> mtu 1480 qdisc noop > link/sit 0.0.0.0 brd 0.0.0.0 > > -Later Looks to me that you probably have eth0 connected to the network. But your routing information is pointing everything to eth1. That is probably why you can not ping anything. I would recommend you disable one of the ethernet cards. Your current configuration has both interfaces in the same subnet. Unless you are trying to bind both interfaces together or something that will most likely cause you problems. Work on getting one interface setup correctly first. Then provide some information on what you are trying to do with both interfaces and someone here can probably help. -- Scot L. Harris webid@xxxxxxxxxx "Money is the root of all money." -- the moving finger
