|
Ever since I upgraded my RH7.3 box to Fedora Core
2, I have not been able to use my network card. It seems something in my setup
thinks I want IPv6 instead of IPv4. During the boot process, I get a message
saying that eth0 is started but when I do an 'ifconfig -a ', all I have is a
sit0 device and no eth0.
My ethernet card is a Netgear FA311 and the kernel release is
2.6.5-1.358
The entries in /var/log/messages seem to show everthing is OK as far as I
know. Here are some of them
kernel: NET: Registered protocol family 16
...
kernel: NET: Registered protocol family 2
kernel: IP: routing cache has table of 4096 buckets, 32Kbytes
kernel: TCP: Hash tables configured (established 32768 bind 65536)
kernel: Initializing IPsec netlink socket
kernel: NET: Registered protocol family 1
kernel: NET: Registered protocol family 17
...
sysctl: net.ipv4.ip_forward = 0
...
sysctl: net.ipv4.conf.default.rp_filter = 1
...
network: Setting network parameters: succeeded
...
kernel: natsemi dp8381x driver, version1.07+LK1.0.17, Sep 27, 2002
kernel: originally by Donald Becker becker@xxxxxxxxx
kernel: 2.4.x kernel port by Jeff Garzik, Tjeerd
Mulder
kernel: PCI: Found IRQ 11 for device 0000:00:08.0
kernel: eth0: NatSemi DP8381[56] at 0x1a858000 <hw addr>, IRQ
11
kernel: NET: Registered protocol family 11
kernel: Disable privacy extensions on device 022db720(lo)
kernel: IPv6 over IPv4 tunneling driver.
The only thing that look at all suspect to me are the mention of the 2.4.x
kernel driver and the IPv6 over IPv4 tunneling driver.
Does this mean that someting in the kernel is set
to use only IPv6?
If I boot from the CD in rescue mode and answer Yes
when asked if I want to start the network, eth0 is configured but when I boot
normally I always get sit0. I have tried setting NETWORKING_IPV6=NO in
/etc/sysconfig/network and even tried renaming all the IPV6 related files in
/etc/sysconfig/network-scripts to no avail.
Any help would be appreciated.
Thanks,
Steve |
