On Thu, 2004-08-19 at 22:16, Kellie Blackwell wrote: > Ever since I upgraded my RH7.3 box to Fedora Core 2, I have not been > able to use my network card. It seems something in my setup thinks I > want IPv6 instead of IPv4. During the boot process, I get a message > saying that eth0 is started but when I do an 'ifconfig -a ', all I > have is a sit0 device. > > While looking at /var/log/messages I see an entry that says: > > "IPv6 over IPv4 tunneling driver" > > Does this mean that someting in the kernel is set to use only IPv6? > > If I boot from the CD in rescue mode and answer Yes when asked if I > want to start the network, eth0 is configured but when I boot normally > I always get sit0. I have tried setting NETWORKING_IPV6=NO in > /etc/sysconfig/network and even tried renaming all the IPV6 related > files in /etc/sysconfig/network-scripts to no avail. I don't know what brand nic you have but I ran into similar problems with a 3Com 3C509B (think thats the model). I finally had to scrap it and get something different. I think some of the older cards are no longer supported. This may be whats happening with your card. -- Thomas E. Dukes <edukes@xxxxxxxxxx>