Hello,
I have a very specific issue. I am running FC 1. I have DSL and was able to get my connection working. The only problem is that I cannot get to any address that ends with the att.net domain. AT&T is my provider for DSL, (Well Covad really). I have the following interface setup:
eth0 Link encap:Ethernet HWaddr 00:60:89:62:4A:33
UP BROADCAST RUNNING MULTICAST MTU:1492 Metric:1
RX packets:6289 errors:0 dropped:0 overruns:0 frame:0
TX packets:2068 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1366788 (1.3 Mb) TX bytes:327183 (319.5 Kb)
Interrupt:11 Base address:0x8f00
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:3568 errors:0 dropped:0 overruns:0 frame:0
TX packets:3568 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:3081891 (2.9 Mb) TX bytes:3081891 (2.9 Mb)
ppp0 Link encap:Point-to-Point Protocol
inet addr:66.167.237.206 P-t-P:172.31.255.252 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:5199 errors:0 dropped:0 overruns:0 frame:0
TX packets:867 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:573007 (559.5 Kb) TX bytes:127302 (124.3 Kb)
Here is the associated routing table
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
172.31.255.252 * 255.255.255.255 UH 0 0 0 ppp0
169.254.0.0 * 255.255.0.0 U 0 0 0 lo
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
default 172.31.255.252 0.0.0.0 UG 0 0 0 ppp0
I have taken down the firewall and it does not matter. I can resolve the IP of the domain but cannot get to the website, get mail. ping or traceroute. I seem to be able to go everywhere else on the net.
Any Ideas?
Is there any other security options besides the Network firewall that could be causing an issue.
Thanks
Nate
--
() ascii ribbon campaign -
/\ against html mail
against microsoft attachments
