I installed Fedora Core 2 on a Dell Poweredge 2400. The Dell has a PERC2 RAID controller card. I setup a simple RAID-0 array to install Linux on. The install went well--no problems. However, after finishing the install and rebooting I get this: First I get the grub menu, then when booting I get: audit(...): initialized agpgart: unable to determine aperture size agpgart: unable to determine aperture size (not a typo, the above appears twice) Red Hat nash version 3.5.22 starting sda: asking for cache data failed sda: assuming drive cache: write through (here is just hangs) If I reboot and edit the default grub parameters and remove rhgb and quiet, I get: (lots of info) Loading megaraid.ko module PCI: Found IRQ 11 for device ... megaraid: found ... scsi0:Found MegaRAID controller at ..., IRQ 11 megaraid: ... detected one logical drive megaraid: channel[0] is raid megaraid: channel[1] is raid scsi0: LSI Logic MegaRAID 1.01 ... Using cfq io scheduler scsi0: scanning scsi channel 0 for logical drives ... SCSI device sda 70770688 512-byte hdwr sectors (36235 MB) sda: asking for cache data failed sda: assuming drive cache: write through sda: sda1 sda2 sda3 Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 scsi0: scanning scsi channel 4 [P0] for logical drives Vendor: DELL Model: 1x6 U2W SCSI BP Rev: 5.35 Type: Processor ANSI SCSI revision: 02 scsi0: scanning scsi channel 5 [P1] for logical drives Loading aic7xxx.ko module PCI: Found IRQ 14 for device ... PCI: Found IRQ 5 for device ... (here is just hangs) I don't believe it's hardware--other Operating Systems work OK on this box. Any ideas or suggestions? Thanks, <> Jim
