On Mon, 2004-07-05 at 18:30 -0700, Barry Yu wrote: > After 5 days with the ddclient installed and configured, today I noticed > that my internet IP address has changed, but the ddclient is not > updating this change into my account in dyndns.org. > The rpm package I downloaded is from dyndns.org. > I also tried yum install ddclient from freshrpms. > But both packages installation results are the same: Getting this > message from the mail from ddclient to root : " Caught SIGTERM ; exiting ". > My fc2 is behide a Linksys router BEFW11s4 ver.2 - Never updated bios. > May be I really don't know how to configured the /etc/ddclient.conf > correctly, below is the content of it and see if any one can help ; > #fw-login=admin, fw-password=XXXXXX # FW login and > password You need to uncomment the above line and put in your password. > # > ## To obtain an IP address from FW status page (using fw-login, fw-password) > #use=fw, fw=192.168.1.254/status.htm, fw-skip='IP Address' # found after > IP Address You need to also uncomment the above line and change the fw= line to the ip/address to the status page on your linksys router. As in mine is something like this... ## To obtain an IP address from FW status page (using fw-login, fw- password) use=fw, fw=192.168.1.1/RouterStatus.htm, fw-skip='IP Address' # found after IP Address You also may need to disable ecn in the kernel by adding the following line to your /etc/sysctl.conf file.. net.ipv4.tcp_ecn = 0 May or may not need to reboot after adding that line (think there is a command you can run to take affect without rebooting). -- Mike Chambers Madisonville, KY "It's always better to hurt a little now, than to hurt a lot later!"
