On Wed, 16 Jun 2004 15:06:38 -0500 (CDT) dsavage@xxxxxxxxxxx wrote: > > Louis, > > I will assume you have not changed this hardware configuration since > upgrading from RH9 to FC2... > > I just ran a search for "2940" on my fedora-list e-mail file. In an April > 8 post to this list Stephen Bodnar said: > > "The trick, as another pointed out is to load the aic7xxx_old module. I > have an Adaptec 2940 running my tape drive, and with the aic7xxx loaded, > modprobe shows the scsi card and tape drive, but it will not actually run. > tar -tvf /dev/st0 would just return "device not found". As soon as I do an > insmod aic7xxx_old it comes right up. Stephen" > > Sounds like this would be worth trying. > > --Doc > Robert G. (Doc) Savage, BSE(EE), CISSP, RHCE | Fairview Heights, IL > Fedora Core 1 kernel 2.4.22-1.2188.nptl on P-III/M IBM Thinkpad A22p > "Perfection is the enemy of good enough." > -- Admiral of the Fleet Sergei G. Gorshkov > > As you assumed, the hardware is exactly the same as it was with RH9. I just did a reinstall from scratch because I made so many changes to RH9 that the system was unupgradable. In my case, I am able to read single volume tapes but when come the time to change the tape, that is where it fails. It looks like the end of tape is not well detected. I will try with aic_7xxx_old tonight to see if there is any changes. If there is issues with scsi drivers, that could be what is my other problem with my Plextor CD Writer who hangs the system with a scsi reset when I try to write a CD... But I don't know if it is realy related to the driver because the same problem appears even with the other SCSI adaptor I have (ncr53c875). Louis
