I just can't get my mass storage Olympus camera c4000 usb to work. I just can't mount it. It stops dead or in Konquerer it "stalls". I checked out with dmesg and got this :
hub 1-0:1.0: over-current change on port 4
usb 3-1: new full speed USB device using address 2
SCSI subsystem initialized
Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: OLYMPUS Model: C4100Z/C4000Z Rev: 1.00
Type: Direct-Access ANSI SCSI revision: 02
USB Mass Storage device found at 2
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
usb 2-1: new low speed USB device using address 2
EXT3 FS on hdb2, internal journal
SCSI device sda: 256000 512-byte hdwr sectors (131 MB)
sda: assuming Write Enabled
sda: assuming drive cache: write through
sda:<6>input: USB HID v1.10 Mouse [Logitech USB-PS/2 Optical Mouse] on usb-0000:00:10.0-1
sda1
device-mapper: 4.1.0-ioctl (2003-12-10) initialised: dm@xxxxxxxxxxxxxx
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
hdd: command error: status=0x51 { DriveReady SeekComplete Error }
hdd: command error: error=0x54
end_request: I/O error, dev hdd, sector 937984
My fstab is the following : dev/sda1 /mnt/camera auto, noauto, rw, users, 0 0 Any ideas please which can help me on this one? Thanks in advance, John Brennan-Sardou
