Hi All -- I recently picked up an eMachine 6805, and got it up and running FC2, using the 64-bit version of the OS. Overall, it's not bad. I realize that the Broadcom 802.11g chip is a LONG way from being supported, at all (any change in this?), so I went out a picked up a Netgear WG511, 802.11g. This card uses the prism54 module / driver, and works VERY well if I do not use WEP. However, if I'm using WEP, it doesn't work at all. It cannot fetch an IP address, or anything. The hex key is being stored in /etc/sysconfig/networking/devices/keys-eth1, in the format: KEY=s:XXXXXXXXXXXXX I've tried with several different keys (always key 1 on the router), and two different routers / access points / firewalls. Under Windows, this same card has no problems. Is WEP working with prism54? What about on the 64-bit kernel? What else am I missing? --Anthony
