Hi,
almost same here with Radeon 9600 Pro. If you'll look a bit further in XOrg.log you will probably find something similar to
(WW) RADEON(0): Direct rendering not yet supported on Radeon 9500/9700 and newer cards
Regards, vadim tarassov.
Miles Sabin wrote:
I've just done a fresh FC2 install on a Sony PGC-Z1XSP which comes with an ATI Radeon Mobility M6 LY and a 1400x1050 panel. 2D is fine, but according to glxinfo (and visible with glxgears and gl apps) direct rendering isn't enabled.
I believe that the standard kernel and xorg modules should support 3D acceleration with this chip, so there's clearly something wrong with my setup. I can't see anything obvious (to me) amiss and I've checked bugzilla and STFA'd without finding anything helpful, so any advice from this list would be much appreciated.
lspci -v gives me this for the controller,
01:00.0 VGA compatible controller: ATI Technologies Inc Radeon \ Mobility M6 LY (prog-if 00 [VGA]) Subsystem: Sony Corporation: Unknown device 8140 Flags: bus master, stepping, fast Back2Back, 66Mhz, medium \ devsel, latency 66, IRQ 9 Memory at d8000000 (32-bit, prefetchable) I/O ports at 3000 [size=256] Memory at d0100000 (32-bit, non-prefetchable) [size=64K] Capabilities: [58] AGP version 2.0 Capabilities: [50] Power Management version 2
I find the following in /var/log/messages,
kernel: Linux agpgart interface v0.100 (c) Dave Jones kernel: agpgart: Detected an Intel 855PM Chipset. kernel: agpgart: Maximum main memory to use for agp memory: 941M kernel: agpgart: AGP aperture is 256M @ 0xe0000000 ... kernel: [drm] Initialized radeon 1.9.0 20020828 on minor 0
However, lsmod doesn't show the radeon module, which I think should be expected.
My xorg.conf includes,
Section "Module" Load "dbe" Load "extmod" Load "fbdevhw" Load "glx" Load "record" Load "freetype" Load "type1" Load "dri" EndSection
and,
Section "DRI" Group 0 Mode 0666 EndSection
And /var/log/Xorg shows the controller being correctly detected and identified and the dri/drm/ati/radeon modules loading successfully. However, towards the end I see,
(II) RADEON(0): Direct rendering disabled
Any help and/or pointers would be much appreciated. Any other relevant info available on request.
TIA ...
Cheers,
Miles
