During boot-up, my eth0 card does not come up. I see my router lights flashing as if it is calling out to DHCP. But, after a long period of time it fails. I tried using the network configuration panel and the same thing happens. It acts like a firewall is active and preventing the DHCP response from coming back. But I deselected the firewall option during install. I tried a static IP and gave the router as the gateway. But, I could not reach any other system. This was never a problem in FC1. I never had to do anything other than tell it to use dhcp. Has anyone else had a problem like this? My card is a Linksys FA310tx. Mark