Hi all. First of all, let me apologise for the wrapping of this email. Let me describe my setup, and the processes that have led me to finding a solution for a problem which only existed when I had upgraded from the 2.4 FC1 kernel, to the 2.6 FC2 kernel. I have an external RAID device, attached to SCSI host adapter 0 (aic79xx) in my server. I also have an internal 18gb SCSI drive attached to SCSI host adapter 1 (aic79xx). Under the 2.4 kernel, the RAID device was not automatically attached to the machine during boot, thus a line had to be added to /etc/rc.sysinit to manually attach it (echo "scsi add-single-device 0 0 1 1" > /proc/scsi/scsi), which worked fine. I attached it after the LoadModules area. This worked, attaching the RAID device as /dev/sdb. However, when I upgraded to the 2.6 kernel and rebooted, the kernel was suddenly very efficient, and COULD attach the RAID device without any extra special attention. Thats when I ran into my problem. It was attaching, logically, SCSI host adapter 0 first, which added the RAID device as /dev/sda, and the internal SCSI drive as /dev/sdb. This was not desirable. I tried changing the order of the scsi adapters in /etc/modules.conf, to load the aic79xx module first, reran mkinitrd and rebooted. No effect. Through trial and error, a good friend of mine found the solution. If you wish you change the SCSI controller module load order, and make one module load before another, as was necessary in my case, try the following: mkinitrd -f -v --preload=aic79xx /boot/initrd-2.6.5-1.358smp.img 2.6.5-1.358smp This resulted in the aic79xx being loaded before the aic7xxx, and this correctly labelling the devices. The internal SCSI using aic79xx became /dev/sda, and the external RAID using aic7xxx became /dev/sdb. I hope this solves a few headaches out there. Enjoy, and good luck, Dan
