Scot L. Harris wrote:
On Sun, 2004-05-09 at 00:16, david walcroft wrote:
Hi, It does not worry me or effect using the net - but just
inquiring why - are the IP's from 'ifconfig' and 'netstat -nr'
different.
ifconfig
inet addr:203.45.135.80 Bcast:255.255.255.255 Mask:255.255.252.0
netstat -nr
[david@reddwarf david]$ sudo netstat -nr
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt
Iface
192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0
eth2
203.45.132.0 0.0.0.0 255.255.252.0 U 0 0 0
eth1
169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0
eth2
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
0.0.0.0 203.45.132.1 0.0.0.0 UG 0 0 0
eth1
Thanks david
ifconfig is showing you the settings on your machines interface. The
netstat -rn command shows you the routing table on your machine.
Because you have a 22 bit subnet subnet mask the actual network has a
usable address range from 203.45.132.1 to 203.45.135.254. (or a
possible 1022 hosts).
Your machines address happens to be towards the end of the usable IP
address range (203.45.135.80).
You also have a second ethernet card on network 192.168.0.0/24, your
ifconfig information does not include your machines IP address on that
network.
The 169.254.0.0 address I believe is for automatic configuration of
interfaces. I have seen this on windows boxes which fail to get their
DHCP configurations. I think there is an RFC which describes this.
Have not read it so can not provide any details on it.
The 127.0.0.0 is for your local loop back address.
And the 0.0.0.0 is for your default gateway. In this case your machine
is configured to send packets to 203.45.132.1 (which appears to be your
networks default gateway) if the destination IP address does not fall
within one of the other local networks defined on your system.
Thanks Scot,just what I needed and I always have the 169.254.0.0 address it must
be my ISP,I'll have to read up on subnet masks.
david
