Re: yum update 2179 kernel

Yeah, sounds like your problem is more complicated than mine was. The only problems I saw after I updated my kernel is that the default kernel did not change to 2179, but it did show up in GRUB at boot. All I did was change the default and I was up and going.

Now, for you, I'd recommend you run "yum update" another time to see if it can't finish the job. Then reboot. If no joy there, I personally would back up my data NOW and take a chance and get webmin to try and do the job. If you've got a day or two to see more posts on this for better advice, you would be wise to get them all before making any moves.

Best of luck to you...

John Fleming wrote:

suggest update webmin under webmin configuration module, it's under
"Hardware"

OK, I do have the GRUB module for WebMin.  When I click it, it says GRUB is
not installed.  That is consistent with yum saying it couldn't find a boot
loader and my not finding a /boot/grub.conf file.  However, I know Grub was
installed when I did the initial FC1 install, AND

1.  When I reboot, I get the graphical screen that says GRUB 0.83, and a
choice of 2 kernels, 2115 and 2174.

So why does it think that grub is not installed - Did the conf file just
disappear?  Do you think I should go ahead and use Webmin's grub install?