Hi, I'm trying to access a SCSI tape drive DDS-3 on Fedore core 1. In the messages and dmesg it shows up fine, but I can't run mt command's on the drive! When connected to another machine (some controller) but running RH9 the drive works fine. Any hints would be nice. Dmesgs: PCI: Found IRQ 11 for device 00:08.0 ncr53c8xx: at PCI bus 0, device 8, function 0 ncr53c8xx: 53c810a detected ncr53c810a-0: rev 0x23 on pci bus 0 device 8 function 0 irq 11 ncr53c810a-0: ID 7, Fast-10, Parity Checking scsi1 : ncr53c8xx-3.4.3b-20010512 Vendor: HP Model: C1537A Rev: L610 Type: Sequential-Access ANSI SCSI revision: 02 Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0 sr0: scsi3-mmc drive: 40x/40x writer cd/rw xa/form2 cdda tray st: Version 20030406, bufsize 32768, max init. bufs 4, s/g segs 16 Attached scsi tape st0 at scsi1, channel 0, id 5, lun 0 ncr53c810a-0-<5,*>: FAST-10 SCSI 10.0 MB/s (100 ns, offset 8) st0: Block limits 1 - 16777215 bytes. ncr53c810a-0: releasing host resources ncr53c810a-0: resetting chip ncr53c810a-0: host resources successfully released scsi : 1 host left. TIA Martijn
