I have a hard drive in an external case connected to my computer via a USB port. It has three ext3 partitions and one VFAT partition. Under RH9, the partitions of this drive showed up as SCSI devices. When I upgraded to FC1, the device can no longer be seen. I'd like some help to determine how to make it accessible again. Here is what I have at this point: I think that I should have a /proc/bus/usb/devices directory. I have /proc/bus, but no usb. My /proc/scsi/scsi file contains the line: "Attached devices: none". I executed "cd /usr/src/linux;make xconfig". The following settings are set to Yes except that those followed by (m) are set to Module: SCSI support SCSI Support SCSI disk support Enable extra checks in new queueing code Probe all LUNs on each SCSI device Verbos SCSI error reporting File systems Kernel automounter version 4 support Ext3 journaling file system DOS FAT fs support MSDOS fs support (m) VFAT (Windows 95) fs support (m) Virtual memory file system support /proc file system support Second extended fs support USB support Support for USB Preliminary USB device filesystem USB Mass Storage support USB Mass Storage verbose debug Of course, I have more settings than these, but I think that these are what are applicable.
