Srinivasan S wrote:
On Sat, 06 Mar 2004 Aaron Matteson wrote :I used redhat-config-network, set the eth0 to dhcp, saved it, restarted the network, and it worked perfectly.
Srinivasan S became daring and sent these 2.9K bytes,
Hi Folks
Yesterday I had posted on a problem I have with the DHCP not responding to my cable modem setup. I got a lot of answers but didn't change the situation.
My setup : eth0 - local n/w eth1 - cable modem, set to request for DHCP The error is that I do not get a client IP. (This was the error I had previously also.)
I went ahead and did a little more .. since this is a dual boot I booted windows and got my ip status. Then in Fedora I set it to the ip obtained via windows, set the gateway and subnet mask and the primary DNS and secondary DNS. Activated it and it worked beautifully.
This means that my NIC is fine, the modem is communicating to the correct NIC.The only problem is now the DHCP client configuration. In addition I also turned off Firewall and the DHCPD that was running on eth0. No success.
Can someone help me on this now that I have been able to zero in that the only issue is setting up dhcp client.
I recently engaged this exact problem exc. with a WinXP machine. How i solved it was to grab the IP/dns server addresses by hand from the WinXP machine and enter them statically to the linux box. This can be done because you are getting a static address anyways, the DHCP server is just a formality to make things easier.
Just enter the ip addy, subnet and the gateway manually, then add the dns servers to /etc/resolv.conf then powerdown the modem then power it back up (not from the soft shutdown button on the top of the modem, just pull the plug and put it back in) and you should be set.
This is what i had to do, given you are having the same issue as i had, i suspect this should resolve your problem.
-- /\o Aaron M Matteson - http://cryptosystem.us /\/ /\ Real programmers don't document. If it was hard to write, / \ it should be hard to understand! -------------------------------------------------------------------------- /~\ The ASCII Ribbon Campaign Against HTML Email! \ / X All that is gold does not glitter, not all those who wander / \ are lost --jrr tolkien
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
Hi Aaron
I already did what you just described and it works.
Does this mean there is no way to setup dhcp client ? Doesn't appeal that something is possible in stupid windows
and not in linux .. hmmm
Regards
Srini
The one time I had a problem was when there was a default gateway set on the other adapter :-(.
Removed that error and again, flawless operation.
At times when there is a problem with the cable signal and it burps I have had to power cycle the modem but it always comes back right away. I have never had to manually input the values received from the DHCP server and mine works flawlessly.
