I had an issue with that same 3com card, 3c509, and the 3c905-tx both did not work in FC1, I swapped in two newer SMC cards and they both work perfectly now. I attributed it to bad drivers. *shrug* Ron -----Original Message----- From: Mike Klinke [mailto:lsomike@xxxxxxxxxx] Sent: Wednesday, February 18, 2004 10:52 AM To: fedora-list@xxxxxxxxxx Subject: Re: Network Functionality Zero On Wednesday 18 February 2004 09:09, Rodolfo J. Paiz wrote: > > [root@firewall root]# cat /etc/sysconfig/network-scripts/ifcfg-eth1 > # 3Com 3C509B EtherLink III:Unknown > DEVICE=eth1 > ONBOOT=yes > BOOTPROTO=none > ZEROCONF=no > IPADDR=200.30.141.29 > NETMASK=255.255.255.248 > GATEWAY=200.30.141.25 > I doubt this will have anything to do with the problem but I'm curious as to the syntax of your ZEROCONF parameter. I have only seen the syntax: NOZEROCONF=yes to disable the service. Your entry above doesn't look like what I've seen in the documentation and according to your routing table your zeroconf is most certainly running, is that what you intended? Regards, Mike Klinke Regards, Mike Klinke -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
