On Sun, 15 Feb 2004, Robert Hartung* wrote: > > > Hi all, > I have a functioning FC1 with all updates. I have added a Belkin PC133 > RAID/IDE hardware controller and went through their hardware setup to make a > mirrored pair (for data use). > > These drives are seen as hde and hdg as reported by dmesg on boot. Now, I > cannot find any documentation on how to get to disk druid after installation to > make partitions and make them function as a RAID 1 device. I can't see any > documentation re: fdisk that allows that utility to make a RAID 1 set. > > Where can I go to read and get this post-installation data-only RAID 1 setup? I had similar problems at one point - because linux doesn't access drives through the controller's BIOS, but rather direct to hardware (that's the explaination I was given), these sorts of RAID cards just don't work. Of course, some do... -- Sam Barnett-Cormack Software Developer | Student of Physics & Maths UK Mirror Service (http://www.mirror.ac.uk) | Lancaster University
