Hi, i have a openmosix cluster on two fedora machines but one has 2 network cards this is pc1, pc1 is my main pc with access to the local network and Internet it also has all the devises. there's a crossover cat5e cable going from eth1 (100.100.100.50) to the onboard network card on pc2 this link works fine samba file share seemed to like it. but when i try to run openmosix it gives me the error ------------------------------------------------------------------- root@blu3cat2 mnt]# /etc/init.d/openmosix start openMosix: Using map file /etc/openmosix.map openMosix: WARN: Invalid configuration in map-file /etc/openmosix.map openMosix: Falling back to autodiscovery mode using /sbin/omdiscd Initializing openMosix... openMosix configuration was successful :) -------------------------------------------------------------------- it all works but its using a different config file and when i show status -------------------------------------------------------------------- [root@blu3cat2 mnt]# /etc/init.d/openmosix status openMosix: Using map file /etc/openmosix.map openMosix: WARN: Invalid configuration in map-file /etc/openmosix.map openMosix: Falling back to autodiscovery mode using /sbin/omdiscd This is OpenMosix node #6 Network protocol: 2 (AF_INET) OpenMosix range 6-6 begins at 192.168.0.6 Total configured: 1 -------------------------------------------------------------------- for some reason its sharing on the wrong network (eth0) on pc1 here is my .map file if any one can help me. -------------------------------------------------------------------- # openMosix CONFIGURATION # =================== # # Each line should contain 3 fields, mapping IP addresses to openMosix node-numbers: # 1) first openMosix node-number in range. # 2) IP address of the above node (or node-name from /etc/hosts). # 3) number of nodes in this range. # # Example: 10 machines with IP 192.168.1.50 - 192.168.1.59 # 1 192.168.1.50 10 # # openMosix-# IP number-of-nodes # ============================ 1 100.100.100.50 2 2 100.100.100.51 1
