Hello all, First of all I'm new to this list and if I am in the wrong spot I apologize in advance. I just installed Fedora on a couple computers, and all worked well except... I just purchased without doing research(bad me) a dlink DWL-520 PCI wireless ethernet card. Fedora detects the card as Prism 2.5 Wavelan chipset. When I try to activate the connection from devices, I get the message "orinoco_pci device eth0 does not seem to be present, delaying initialization." If I go in under the hardware tab and click edit, it chooses irq 11 which I believe is correct, then I hit ok and then I get: Command failed: /sbin/modprobe orinco_pci irq=11 Output: Warning: ignoring irq=11, no such parameter in this module Warning: ignoring irq=11, no such parameter in this module /lib/modules/2.4.22-1.2115/nptlsmp/kernel/drivers/net/wireless/orinco_pci.o: init_module: No such device /lib/modules/2.4.22-1.2115/nptlsmp/kernel/drivers/net/wireless/orinco_pci.0: insmod /lib/modules/2.4.22-1.2115.nptlsmp/kernel/drivers/net/wireless/orinoco_pci.o failed /lib/modules/2.4.22-1.2115/nptlsmp/kernel/drivers/net/wireless/orinco_pci.0: insmod orinco_pci failedHint: insmod errors can be caued by incorrect module parameters, including invalid IO or IRQparameters. You may findout more information in syslog or the output from dmesg If anyone has had any experience, or has any suggestions for me on this it would be greatly appreciated! Thanks in advance! Miles
