|
I have been running Red Hat 7.2 sucessfully on my
machine which is connected through a switch box to a Daewoo CMC-1707B monitor
which was set to custom during install with the correct scan
frequency.
After a fresh install of Fedora I get a black
screen during boot at the point I assume there should be some logo
displayed. My chosen monitor is not on the list during setup and there
dosen't appear to be a 'custom' option but I chose a similar model with the same
scan rates and a similar model then reset the scan rates.
Any suggestions please, as I am unable to log in to
make any changes or access the machine.
Thanks
John
|
