Hi,
I have a problem and would appreciate any advise from anyone in this list.
I had previously installed FC1 on a AMD900 T-Bird processor with no problems and was happily running it.
Recently, the motherboard died and so I got a new P4 2.6C GHz processor with a HyperThreading enabled 800MHz FSB motherboard and a 1GB dual channel DDR400 RAM. Other than a new Nvidia FX video card, the same set of HDDs and other hardware was used.
I tried to re-install FC1 from scratch with the same set of CDROMs. I just typed 'linux reiserfs' at the boot prompt to enable reiserfs support and the installation went fine until the stage when i finished the package selection (same set as i installed on the old board). When the install image was being transferred to my harddisk, I get an error message that I am out of disk space.
The partitioning I am using in my 40GB harddisk is as follows: /boot (100MB), swap (1024MB), / (20GB), /home (18GB). I even tried the following partition: /boot (100MB), swap(1024MB), / (38GB). But everytime, the same error occurred.
I would definitely appreciate any advise to get FC1 up and running. I have tried searching the fedora-list archives but I cannot find anything.
Thanks in advance.
Rgds, Boon Wee
