I assume the following means it's not disabled... ACPI: have wakeup address 0xc0001000 On node 0 totalpages: 131068 zone(0): 4096 pages. zone(1): 126972 pages. zone(2): 0 pages. ACPI: RSDP (v000 ASUS ) @ 0x000f62b0 ACPI: RSDT (v001 ASUS A7V600 0x42302e31 MSFT 0x31313031) @ 0x1fffc000 ACPI: FADT (v001 ASUS A7V600 0x42302e31 MSFT 0x31313031) @ 0x1fffc0b2 ACPI: BOOT (v001 ASUS A7V600 0x42302e31 MSFT 0x31313031) @ 0x1fffc030 ACPI: MADT (v001 ASUS A7V600 0x42302e31 MSFT 0x31313031) @ 0x1fffc058 ACPI: DSDT (v001 ASUS A7V600 0x00001000 MSFT 0x0100000b) @ 0x00000000 ACPI: Subsystem revision 20031002 ACPI: Interpreter disabled. Zach On Tue, 2003-11-11 at 14:57, Jingcao Hu wrote: > Have you got ACPI working on? I have a HP zt1180 laptop which also uses > on-board VIA 82cXXX sound card. It had the same symptom like yours until I > enabled acpi. > > > > Zach Wilkinson <zachw@xxxxxxxxxxx> writes: > > > On board sound card is a ADI AD1980 SoundMAX 6-channel CODEC S/PDIF out > > interface. Is detected as follows: > > > > [Output from dmesg:] > > Via 686a/8233/8235 audio driver 1.9.1-ac3 > > PCI: Found IRQ 9 for device 00:11.5 > > PCI: Sharing IRQ 9 with 00:10.4 > > via82cxxx: Six channel audio available > > PCI: Setting latency timer of device 00:11.5 to 64 > > via82cxxx: timeout while reading AC97 codec (0xAA0000) > > ac97_codec: AC97 Audio codec, id: ADS112 (Unknown) > > via82cxxx: board #1 at 0xE000, IRQ 9 > > > > [Output from lsmod:] > > via82cxxx_audio 24056 1 (autoclean) > > ac97_codec 17064 0 (autoclean) [via82cxxx_audio] > > uart401 8356 0 (autoclean) [via82cxxx_audio] > > sound 73300 0 (autoclean) [via82cxxx_audio uart401] > > soundcore 6500 4 (autoclean) [via82cxxx_audio sound] > > > > [Output from cat /proc/pci:] > > Bus 0, device 17, function 5: > > Multimedia audio controller: VIA Technologies, Inc. VT8233/A/8235 > > AC97 Audio Controller (rev 96). > > IRQ 9. > > I/O at 0xe000 [0xe0ff]. > > > > Sound Card detection tool identifies it as above, but the test sound > > cannot be heard. From command line, # play <some_wav>.wav also produces > > no sound, as well as no errors. > > System thinks everything is fine but I hear nothing, even when volume is > > turned up. > > Works fine when booted into WinXP. > > > > Zach
