Re: [PATCH] Early boot debugging via FireWire (ohci1394_dma=early)

[Stefan Richter <stefanr@s5r6.in-berlin.de>]

Bernhard Kaindl wrote:
>    after summing up the discussion on previous patches, I'm now submitting the
> patch below for formal review and adoption on branches for mainline inclusion.

I will look a bit more into the details later; for now I have just a
quick comment on the documentation.

> --- linux-2.6.24-rc4/Documentation/debugging-via-ohci1394.txt
> +++ linux-2.6.24-rc4/Documentation/debugging-via-ohci1394.txt
> @@ -0,0 +1,179 @@
> +
> +  Using physical DMA provided by OHCI-1394 FireWire controllers for debugging
> +  ---------------------------------------------------------------------------
> +
> +Introduction
> +------------

There are some really long sentences in it.
Try to use the "." character more often.  :-)

> +Basically all FireWire controllers which are in use today are compliant
> +to the OHCI-1394 specification which defines the controller to be a PCI
> +bus master which uses DMA to offload data transfers from the CPU and has
> +a "Physical Response Unit" which executes specific requests by employing
> +PCI-Bus master DMA after applying filters defined by the OHCI-1394 driver.
> +
> +Once properly configured, remote machines can send these requests to
> +ask the OHCI-1394 controller to perform read and write requests on
> +physical system memory and, for read requests, send the result of
> +the physical memory read back to the requester.

In other words, the FireWire controller can be configured to work as a
bus bridge between FireWire bus and local bus (PCI or PCIe).

And yes, there are security implications.

[...]
> +The OHCI-1394 drivers in drivers/firewire and drivers/ieee1394 initialize
> +the OHCI-1394 controllers to a working state and can be used to enable
> +physical DMA. By default you only have to load the driver, and physical
> +DMA access will be granted to all remote nodes, but it can be turned off
> +when using the ohci1394 driver.

This is correct for ohci1394, and it's a bug.
http://bugzilla.kernel.org/show_bug.cgi?id=7794

firewire-ohci however implements filtered physical DMA.  The only user
of that is the firewire-sbp2 driver which grants SBP-2 targets access
through the physical response unit.  firewire-ohci has at the moment no
option for either unfiltered physical DMA (as needed by firescope at al,
tracked at http://wiki.linux1394.org/ToDo) nor to completely disable
physical DMA.
-- 
Stefan Richter
-=====-=-=== ==-- --==-
http://arcgraph.de/sr/
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/