Re: [PATCH 07/14] Blackfin SPI driver: Add SPI master controller platform device 1

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Tuesday 30 October 2007, Bryan Wu wrote:
> From: Sonic Zhang <[email protected]>
> 
> Signed-off-by: Sonic Zhang <[email protected]>
> Signed-off-by: Bryan Wu <[email protected]>

The patch comments in this series leave a bit to be desired,
especially patches from Sonic.  (Several are like this one:
just a $SUBJECT, no description.)  I've improved them in the
versions I'll be sending on ...

It's worth noting that in this case the $SUBJECT doesn't
relate *at all* to what this patch actually does!  Namely,
it uses the portmux mechanism to add support for two more
SPI buses ... it doesn't add a platform device.

- Dave

> ---
>  drivers/spi/spi_bfin5xx.c |   52 ++++++++++++++++++++++++++------------------
>  1 files changed, 31 insertions(+), 21 deletions(-)
> 
> diff --git a/drivers/spi/spi_bfin5xx.c b/drivers/spi/spi_bfin5xx.c
> index 3f3630c..3bd8359 100644
> --- a/drivers/spi/spi_bfin5xx.c
> +++ b/drivers/spi/spi_bfin5xx.c
> @@ -209,17 +209,26 @@ static void cs_deactive(struct chip_data *chip)
>  	write_FLAG(flag);
>  }
>  
> -#define MAX_SPI0_SSEL	7
> +#define MAX_SPI_SSEL	7
>  
>  /* stop controller and re-config current chip*/
>  static int restore_state(struct driver_data *drv_data)
>  {
>  	struct chip_data *chip = drv_data->cur_chip;
>  	int ret = 0;
> -	u16 ssel[MAX_SPI0_SSEL] = {P_SPI0_SSEL1, P_SPI0_SSEL2, P_SPI0_SSEL3,
> -					P_SPI0_SSEL4, P_SPI0_SSEL5,
> -					P_SPI0_SSEL6, P_SPI0_SSEL7,};
> -
> +	u16 ssel[3][MAX_SPI_SSEL] = {
> +		{P_SPI0_SSEL1, P_SPI0_SSEL2, P_SPI0_SSEL3,
> +		P_SPI0_SSEL4, P_SPI0_SSEL5,
> +		P_SPI0_SSEL6, P_SPI0_SSEL7},
> +
> +		{P_SPI1_SSEL1, P_SPI1_SSEL2, P_SPI1_SSEL3,
> +		P_SPI1_SSEL4, P_SPI1_SSEL5,
> +		P_SPI1_SSEL6, P_SPI1_SSEL7},
> +
> +		{P_SPI2_SSEL1, P_SPI2_SSEL2, P_SPI2_SSEL3,
> +		P_SPI2_SSEL4, P_SPI2_SSEL5,
> +		P_SPI2_SSEL6, P_SPI2_SSEL7},
> +	};
>  	/* Clear status and disable clock */
>  	write_STAT(BIT_STAT_CLR);
>  	bfin_spi_disable(drv_data);
> @@ -234,9 +243,9 @@ static int restore_state(struct driver_data *drv_data)
>  		int i = chip->chip_select_num;
>  
>  		dev_dbg(&drv_data->pdev->dev, "chip select number is %d\n", i);
> -
> -		if ((i > 0) && (i <= MAX_SPI0_SSEL))
> -			ret = peripheral_request(ssel[i-1], DRV_NAME);
> +		if ((i > 0) && (i <= MAX_SPI_SSEL))
> +			ret = peripheral_request(
> +				ssel[drv_data->master->bus_num][i-1], DRV_NAME);
>  
>  		chip->chip_select_requested = 1;
>  	}
> @@ -329,7 +338,6 @@ static void u8_reader(struct driver_data *drv_data)
>  	write_TDBR(0xFFFF);
>  
>  	dummy_read();
> -
>  	while (drv_data->rx < drv_data->rx_end - 1) {
>  		while (!(read_STAT() & BIT_STAT_RXS))
>  			continue;
> @@ -640,7 +648,6 @@ static void pump_transfers(unsigned long data)
>  	message = drv_data->cur_msg;
>  	transfer = drv_data->cur_transfer;
>  	chip = drv_data->cur_chip;
> -
>  	/*
>  	 * if msg is error or done, report it back using complete() callback
>  	 */
> @@ -1202,17 +1209,20 @@ static inline int destroy_queue(struct driver_data *drv_data)
>  	return 0;
>  }
>  
> -static int setup_pin_mux(int action)
> +static int setup_pin_mux(int action, int bus_num)
>  {
>  
> -	u16 pin_req[] = {P_SPI0_SCK, P_SPI0_MISO, P_SPI0_MOSI, 0};
> +	u16 pin_req[3][4] = {
> +		{P_SPI0_SCK, P_SPI0_MISO, P_SPI0_MOSI, 0},
> +		{P_SPI1_SCK, P_SPI1_MISO, P_SPI1_MOSI, 0},
> +		{P_SPI2_SCK, P_SPI2_MISO, P_SPI2_MOSI, 0},
> +	};
>  
>  	if (action) {
> -		if (peripheral_request_list(pin_req, DRV_NAME)) {
> +		if (peripheral_request_list(pin_req[bus_num], DRV_NAME))
>  			return -EFAULT;
> -		}
>  	} else {
> -		peripheral_free_list(pin_req);
> +		peripheral_free_list(pin_req[bus_num]);
>  	}
>  
>  	return 0;
> @@ -1236,11 +1246,6 @@ static int __init bfin5xx_spi_probe(struct platform_device *pdev)
>  		return -ENOMEM;
>  	}
>  
> -	if (setup_pin_mux(1)) {
> -		dev_err(&pdev->dev, ": Requesting Peripherals failed\n");
> -		goto out_error;
> -	}
> -
>  	drv_data = spi_master_get_devdata(master);
>  	drv_data->master = master;
>  	drv_data->master_info = platform_info;
> @@ -1295,6 +1300,11 @@ static int __init bfin5xx_spi_probe(struct platform_device *pdev)
>  		goto out_error_queue_alloc;
>  	}
>  
> +	if (setup_pin_mux(1, master->bus_num)) {
> +		dev_err(&pdev->dev, ": Requesting Peripherals failed\n");
> +		goto out_error;
> +	}
> +
>  	dev_info(dev, "%s, Version %s, regs_base @ 0x%08x\n",
>  		DRV_DESC, DRV_VERSION, spi_regs_base);
>  	return status;
> @@ -1337,7 +1347,7 @@ static int __devexit bfin5xx_spi_remove(struct platform_device *pdev)
>  	/* Disconnect from the SPI framework */
>  	spi_unregister_master(drv_data->master);
>  
> -	setup_pin_mux(0);
> +	setup_pin_mux(0, drv_data->master->bus_num);
>  
>  	/* Prevent double remove */
>  	platform_set_drvdata(pdev, NULL);
> -- 
> 1.5.3.4
> 


-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

[Index of Archives]     [Kernel Newbies]     [Netfilter]     [Bugtraq]     [Photo]     [Stuff]     [Gimp]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Video 4 Linux]     [Linux for the blind]     [Linux Resources]
  Powered by Linux