Re: [PATCH 2/3] ide: fix drive_is_ready() for non-PCI hosts and CONFIG_IDEPCI_SHARE_IRQ=y

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, 26 Oct 2007 02:30:52 +0200
Bartlomiej Zolnierkiewicz <[email protected]> wrote:

> On Friday 26 October 2007, Alan Cox wrote:
> > On Fri, 26 Oct 2007 01:36:37 +0200
> > Bartlomiej Zolnierkiewicz <[email protected]> wrote:
> > 
> > > 
> > > Need to check if the host is a PCI one before reading IDE_ALTSTATUS_REG.
> > > 
> > > Signed-off-by: Bartlomiej Zolnierkiewicz <[email protected]>
> > 
> > Umm why ? The altstatus register goes back to ST-506 and the original IBM
> > XT hard disk controller card ?
> 
> Thought that there have to be some (non-obvious) reason behing the fact that
> IDE_ALTSTATUS_REG reading was covered by #ifdef CONFIG_IDEPCI_SHARE_IRQ.

Only that reading altstatus is done to get the state without clearing the
IRQ which a status read would do.

Alan
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

[Index of Archives]     [Kernel Newbies]     [Netfilter]     [Bugtraq]     [Photo]     [Stuff]     [Gimp]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Video 4 Linux]     [Linux for the blind]     [Linux Resources]
  Powered by Linux