Re: [2.6.23-rc8-mm2] System hangs (loops?) during boot

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Sat, 29 Sep 2007 02:32:44 +0200 Frans Pop <[email protected]> wrote:

> On Friday 28 September 2007, Frans Pop wrote:
> > My Toshiba Satellite A40 (i386, P4 Mobile) hangs during boot after:
> > Marking TSC unstable due to: possible TSC halt in C2.
> > Time: acpi_pm clocksource has been installed.
> 
> A few new boot attempts show the problem is more likely at:
> Probing IDE interface ide0...
> 
> > It may not actually hang, but rather end up in a loop as after some time
> > the fan goes wild.
> 
> Unfortunately I have no serial port and this seems too early for netconsole, 
> so cannot catch a boot log.
> 
> > Any suggestions where to look before I do a bisect?

Not really, sorry.  I usually start at mm.patch when I don't have a clue.
It mm.patch fails then pop off all the x86 patches (down to
git-ipwireless_cs.patch).

If mm.patch doesn't fail then push on all the memory management patches (up
to mm-test-and-set-zone-reclaim-lock-before-starting-cleanup.patch).

Two iterations should get you into the culprit zone.

But please do bisect it.  
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

[Index of Archives]     [Kernel Newbies]     [Netfilter]     [Bugtraq]     [Photo]     [Stuff]     [Gimp]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Video 4 Linux]     [Linux for the blind]     [Linux Resources]
  Powered by Linux