Re: [PATCH] ahci: enable GHC.AE bit before set GHC.HR

[Jens Axboe <jens.axboe@oracle.com>]

On Fri, Sep 21 2007, Alan Cox wrote:
> On Fri, 21 Sep 2007 12:31:20 +0200
> Jens Axboe <jens.axboe@oracle.com> wrote:
> 
> > On Fri, Sep 21 2007, Peer Chen wrote:
> > > According to the description of section 5.2.2.1 and 10.1.2 of AHCI specification rev1_1/rev1_2, GHC.HR shall only be set to ¡®1¡¯
> > > by software when GHC.AE is set to ¡®1¡¯.
> > > 
> > > Signed-off-by: Peer Chen <peerchen@gmail.com>
> > > ---
> > > --- linux-2.6.23-rc7/drivers/ata/ahci.c.orig	2007-09-20 11:01:55.000000000 -0400
> > > +++ linux-2.6.23-rc7/drivers/ata/ahci.c	2007-09-20 11:07:31.000000000 -0400
> > > @@ -834,6 +834,10 @@ static int ahci_reset_controller(struct 
> > >  	void __iomem *mmio = host->iomap[AHCI_PCI_BAR];
> > >  	u32 tmp;
> > >  
> > > +        /* turn on AHCI mode before controller reset*/
> > > +        writel(HOST_AHCI_EN, mmio + HOST_CTL);
> > > +        (void) readl(mmio + HOST_CTL);  /* flush */
> > > +
> > >  	/* global controller reset */
> > >  	tmp = readl(mmio + HOST_CTL);
> > >  	if ((tmp & HOST_RESET) == 0) {
> > 
> > I appreciate the readl() flushes, but in this particular case we end up
> > reading the exact offset again below.
> 
> The code above is wrong btw - it is an iomap so both the new and existing
> code should be using ioread* not readl

Happy converting :-)

-- 
Jens Axboe

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/