Re: PROBLEM: Network sky2 Module

[Bill Davidsen <davidsen@tmr.com>]

ben soo wrote:
> i'm experiencing this problem myself.  i have 2 servers, one using 
> X86_64 kernel version 2.6.23-rc5 on a 100Mbit network and one with i386 
> kernel version 2.6.23-rc6 on a 1Gbit network.
>
> They both have this issue with the sky2 network device driver whereby 
> the device would stop working and need to be brought down and back up.
>
> On the X86_64 kernel on a 100Mbit network, this is a very occasional 
> thing, while on the i386 kernel on a 1Gbit network the device only works 
> for a few minutes at a time.  If i set the MTU to 7200 then the device 
> seems to stay functional, but then i see long delays when it's talking 
> to 100Mbit devices with standard 1500 MTU that are outside of its LAN 
> segment.
>
> This last might be an artifact caused by the firewall, i dunno.
Yes, I have found that I get far less problem in this area leaving the 
MTU at 1500, then putting a larger MTU (usually 9000) into the routing 
table for segments, or even just machines, where I know there is direct 
connectivity. I use 9000 MTU with my directly connected file server, 
1500 elsewhere. I can go to 9000 for nbd servers as well, assuming the 
connection doesn't pass a firewall.

I have some hints that while the switches I use will speak 10/100/1000 
between machines with different speeds, and will handle jumbo packets 
between machines at the same speed, if I'm going Gbit/jumbo to 
1500/slower performance seems to suffer more than talking smaller 
packets. That may be because window size needs to be even larger or 
something.

I have some legacy machines talking 10Mbit/half on 10base2 cable, I may 
be seeing more of this than the average site. That's legacy as in 
"attached to something expensive to replace."

--
Bill Davidsen <davidsen@tmr.com>
  "We have more to fear from the bungling of the incompetent than from
the machinations of the wicked."  - from Slashdot
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/