Re: [patch] s2ram: kill old debugging junk

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thursday, 16 August 2007 11:16, Pavel Machek wrote:
> 
> This removes old debugging stuff, that should be no longer
> neccessary. It accessed VGA hardware (which may not be ready at this
> point), and used LEDs at port 80 for debugging.
> 
> Signed-off-by: Pavel Machek <[email protected]>

Acked-by: Rafael J. Wysocki <[email protected]>

> diff --git a/arch/i386/kernel/acpi/wakeup.S b/arch/i386/kernel/acpi/wakeup.S
> index ed0a0f2..9cebef7 100644
> --- a/arch/i386/kernel/acpi/wakeup.S
> +++ b/arch/i386/kernel/acpi/wakeup.S
> @@ -11,7 +11,7 @@ # Do we need to deal with A20? It is oka
>  #
>  # If physical address of wakeup_code is 0x12345, BIOS should call us with
>  # cs = 0x1234, eip = 0x05
> -# 
> +#
>  
>  #define BEEP \
>  	inb	$97, %al; 	\
> @@ -52,7 +52,6 @@ wakeup_code:
>  	BEEP
>  1:
>  	mov	$(wakeup_stack - wakeup_code), %sp		# Private stack is needed for ASUS board
> -	movw	$0x0e00 + 'S', %fs:(0x12)
>  
>  	pushl	$0						# Kill any dangerous flags
>  	popfl
> @@ -90,9 +89,6 @@ wakeup_code:
>  	# make sure %cr4 is set correctly (features, etc)
>  	movl	real_save_cr4 - wakeup_code, %eax
>  	movl	%eax, %cr4
> -	movw	$0xb800, %ax
> -	movw	%ax,%fs
> -	movw	$0x0e00 + 'i', %fs:(0x12)
>  	
>  	# need a gdt -- use lgdtl to force 32-bit operands, in case
>  	# the GDT is located past 16 megabytes.
> @@ -102,8 +98,6 @@ wakeup_code:
>  	movl	%eax, %cr0
>  	jmp 1f
>  1:
> -	movw	$0x0e00 + 'n', %fs:(0x14)
> -
>  	movl	real_magic - wakeup_code, %eax
>  	cmpl	$0x12345678, %eax
>  	jne	bogus_real_magic
> @@ -122,13 +116,11 @@ real_save_cr4:	.long 0
>  real_magic:	.long 0
>  video_mode:	.long 0
>  realmode_flags:	.long 0
> -beep_flags:	.long 0
>  real_efer_save_restore:	.long 0
>  real_save_efer_edx: 	.long 0
>  real_save_efer_eax: 	.long 0
>  
>  bogus_real_magic:
> -	movw	$0x0e00 + 'B', %fs:(0x12)
>  	jmp bogus_real_magic
>  
>  /* This code uses an extended set of video mode numbers. These include:
> @@ -153,29 +145,9 @@ #define VIDEO_FIRST_V7 0x0900
>  # Setting of user mode (AX=mode ID) => CF=success
>  mode_set:
>  	movw	%ax, %bx
> -#if 0
> -	cmpb	$0xff, %ah
> -	jz	setalias
> -
> -	testb	$VIDEO_RECALC>>8, %ah
> -	jnz	_setrec
> -
> -	cmpb	$VIDEO_FIRST_RESOLUTION>>8, %ah
> -	jnc	setres
> -	
> -	cmpb	$VIDEO_FIRST_SPECIAL>>8, %ah
> -	jz	setspc
> -
> -	cmpb	$VIDEO_FIRST_V7>>8, %ah
> -	jz	setv7
> -#endif
>  	
>  	cmpb	$VIDEO_FIRST_VESA>>8, %ah
>  	jnc	check_vesa
> -#if 0	
> -	orb	%ah, %ah
> -	jz	setmenu
> -#endif
>  	
>  	decb	%ah
>  #	jz	setbios				  Add bios modes later
> @@ -215,7 +187,6 @@ wakeup_pmode_return:
>  	movw	%ax, %es
>  	movw	%ax, %fs
>  	movw	%ax, %gs
> -	movw	$0x0e00 + 'u', 0xb8016
>  
>  	# reload the gdt, as we need the full 32 bit address
>  	lgdt	saved_gdt
> @@ -239,7 +210,6 @@ wakeup_pmode_return:
>  	jmp	*%eax
>  
>  bogus_magic:
> -	movw	$0x0e00 + 'B', 0xb8018
>  	jmp	bogus_magic
>  
>  
> diff --git a/arch/x86_64/kernel/acpi/wakeup.S b/arch/x86_64/kernel/acpi/wakeup.S
> index 13f1480..fd09434 100644
> --- a/arch/x86_64/kernel/acpi/wakeup.S
> +++ b/arch/x86_64/kernel/acpi/wakeup.S
> @@ -41,7 +41,6 @@ wakeup_code:
>  
>  # Running in *copy* of this code, somewhere in low 1MB.
>  
> -	movb	$0xa1, %al	;  outb %al, $0x80
>  	cli
>  	cld
>  	# setup data segment
> @@ -65,11 +64,6 @@ # Running in *copy* of this code, somewh
>  	cmpl	$0x12345678, %eax
>  	jne	bogus_real_magic
>  
> -  	call	verify_cpu			# Verify the cpu supports long
> -						# mode
> -	testl	%eax, %eax
> -	jnz	no_longmode
> -
>  	testl	$1, realmode_flags - wakeup_code
>  	jz	1f
>  	lcall   $0xc000,$3
> @@ -84,12 +78,6 @@ # Running in *copy* of this code, somewh
>  	call	mode_seta
>  1:
>  
> - 	movw	$0xb800, %ax
> -	movw	%ax,%fs
> -	movw	$0x0e00 + 'L', %fs:(0x10)
> -
> -	movb	$0xa2, %al	;  outb %al, $0x80
> -	
>  	mov	%ds, %ax			# Find 32bit wakeup_code addr
>  	movzx   %ax, %esi			# (Convert %ds:gdt to a liner ptr)
>  	shll    $4, %esi
> @@ -117,14 +105,10 @@ wakeup_32_vector:
>  	.code32
>  wakeup_32:
>  # Running in this code, but at low address; paging is not yet turned on.
> -	movb	$0xa5, %al	;  outb %al, $0x80
>  
>  	movl	$__KERNEL_DS, %eax
>  	movl	%eax, %ds
>  
> -	movw	$0x0e00 + 'i', %ds:(0xb8012)
> -	movb	$0xa8, %al	;  outb %al, $0x80;
> -
>  	/*
>  	 * Prepare for entering 64bits mode
>  	 */
> @@ -200,16 +184,11 @@ wakeup_long64:
>  	 */
>  	lgdt	cpu_gdt_descr
>  
> -	movw	$0x0e00 + 'n', %ds:(0xb8014)
> -	movb	$0xa9, %al	;  outb %al, $0x80
> -
>  	movq    saved_magic, %rax
>  	movq    $0x123456789abcdef0, %rdx
>  	cmpq    %rdx, %rax
>  	jne     bogus_64_magic
>  
> -	movw	$0x0e00 + 'u', %ds:(0xb8016)
> -	
>  	nop
>  	nop
>  	movw	$__KERNEL_DS, %ax
> @@ -220,13 +199,11 @@ wakeup_long64:
>  	movw	%ax, %gs
>  	movq	saved_rsp, %rsp
>  
> -	movw	$0x0e00 + 'x', %ds:(0xb8018)
>  	movq	saved_rbx, %rbx
>  	movq	saved_rdi, %rdi
>  	movq	saved_rsi, %rsi
>  	movq	saved_rbp, %rbp
>  
> -	movw	$0x0e00 + '!', %ds:(0xb801a)
>  	movq	saved_rip, %rax
>  	jmp	*%rax
>  
> @@ -256,20 +233,12 @@ realmode_flags:	.quad 0
>  
>  .code16
>  bogus_real_magic:
> -	movb	$0xba,%al	;  outb %al,$0x80
>  	jmp bogus_real_magic
>  
>  .code64
>  bogus_64_magic:
> -	movb	$0xb3,%al	;  outb %al,$0x80
>  	jmp bogus_64_magic
>  
> -.code16
> -no_longmode:
> -	movb    $0xbc,%al       ;  outb %al,$0x80
> -	jmp no_longmode
> -
> -#include "../verify_cpu.S"
>  	
>  /* This code uses an extended set of video mode numbers. These include:
>   * Aliases for standard modes
> @@ -294,29 +263,9 @@ # Setting of user mode (AX=mode ID) => C
>  .code16
>  mode_seta:
>  	movw	%ax, %bx
> -#if 0
> -	cmpb	$0xff, %ah
> -	jz	setalias
> -
> -	testb	$VIDEO_RECALC>>8, %ah
> -	jnz	_setrec
> -
> -	cmpb	$VIDEO_FIRST_RESOLUTION>>8, %ah
> -	jnc	setres
> -	
> -	cmpb	$VIDEO_FIRST_SPECIAL>>8, %ah
> -	jz	setspc
> -
> -	cmpb	$VIDEO_FIRST_V7>>8, %ah
> -	jz	setv7
> -#endif
>  	
>  	cmpb	$VIDEO_FIRST_VESA>>8, %ah
>  	jnc	check_vesaa
> -#if 0	
> -	orb	%ah, %ah
> -	jz	setmenu
> -#endif
>  	
>  	decb	%ah
>  #	jz	setbios				  Add bios modes later
> 

-- 
"Premature optimization is the root of all evil." - Donald Knuth
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

[Index of Archives]     [Kernel Newbies]     [Netfilter]     [Bugtraq]     [Photo]     [Stuff]     [Gimp]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Video 4 Linux]     [Linux for the blind]     [Linux Resources]
  Powered by Linux