On 08/10/2007 02:30 PM, Michal Piotrowski wrote:
[Adding linux-scsi and Adaptec support to CC]
On 10/08/07, Jegadeesh <[email protected]> wrote:
Hi,
I have a scsi disk on Adaptec ASC-29320 U320. I have created a linux
partition and ext3 filesystem over it.
Now the problem is, whenever the machine is rebooted, the partition
information to the OS is lost and I get an error saying it as a not valid
block device.
But fdisk tool shows the partitions, but "cat /proc/partitions" doesnt have
this. I need to do a "partprobe" and then have to mount it explicitly.
What could be causing this problem. Given below are some of the command
outputs.
Is that the "Adaptec AIC79xx U320 support" (CONFIG_SCSI_AIC79XX) driver? If
so, did you lower the "Initial bus reset delay" (default is 5000 ms) in the
kernel configuration?
Rene.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]
