From: David Rientjes <[email protected]>
e820_hole_size() now uses the newly extracted helper function,
e820_find_active_region(), to determine the size of usable RAM in a range of
PFN's.
This was previously broken because of two reasons:
- The start and end PFN's of each e820 entry were not properly rounded
prior to excluding those entries in the range, and
- Entries smaller than a page were not properly excluded from being
accumulated.
This resulted in emulated nodes being incorrectly mapped to ranges that
were completely reserved and not candidates for being registered as
active ranges.
Signed-off-by: David Rientjes <[email protected]>
Signed-off-by: Andi Kleen <[email protected]>
Cc: Andi Kleen <[email protected]>
Signed-off-by: Andrew Morton <[email protected]>
---
arch/x86_64/kernel/e820.c | 54 +++++++++++++++++++---------------------------
arch/x86_64/mm/numa.c | 8 +-----
2 files changed, 25 insertions(+), 37 deletions(-)
Index: linux/arch/x86_64/kernel/e820.c
===================================================================
--- linux.orig/arch/x86_64/kernel/e820.c
+++ linux/arch/x86_64/kernel/e820.c
@@ -194,37 +194,6 @@ unsigned long __init e820_end_of_ram(voi
}
/*
- * Find the hole size in the range.
- */
-unsigned long __init e820_hole_size(unsigned long start, unsigned long end)
-{
- unsigned long ram = 0;
- int i;
-
- for (i = 0; i < e820.nr_map; i++) {
- struct e820entry *ei = &e820.map[i];
- unsigned long last, addr;
-
- if (ei->type != E820_RAM ||
- ei->addr+ei->size <= start ||
- ei->addr >= end)
- continue;
-
- addr = round_up(ei->addr, PAGE_SIZE);
- if (addr < start)
- addr = start;
-
- last = round_down(ei->addr + ei->size, PAGE_SIZE);
- if (last >= end)
- last = end;
-
- if (last > addr)
- ram += last - addr;
- }
- return ((end - start) - ram);
-}
-
-/*
* Mark e820 reserved areas as busy for the resource manager.
*/
void __init e820_reserve_resources(void)
@@ -364,6 +333,29 @@ void __init add_memory_region(unsigned l
e820.nr_map++;
}
+/*
+ * Find the hole size (in bytes) in the memory range.
+ * @start: starting address of the memory range to scan
+ * @end: ending address of the memory range to scan
+ */
+unsigned long __init e820_hole_size(unsigned long start, unsigned long end)
+{
+ unsigned long start_pfn = start >> PAGE_SHIFT;
+ unsigned long end_pfn = end >> PAGE_SHIFT;
+ unsigned long ei_startpfn;
+ unsigned long ei_endpfn;
+ unsigned long ram = 0;
+ int i;
+
+ for (i = 0; i < e820.nr_map; i++) {
+ if (e820_find_active_region(&e820.map[i],
+ start_pfn, end_pfn,
+ &ei_startpfn, &ei_endpfn))
+ ram += ei_endpfn - ei_startpfn;
+ }
+ return end - start - (ram << PAGE_SHIFT);
+}
+
void __init e820_print_map(char *who)
{
int i;
Index: linux/arch/x86_64/mm/numa.c
===================================================================
--- linux.orig/arch/x86_64/mm/numa.c
+++ linux/arch/x86_64/mm/numa.c
@@ -273,9 +273,6 @@ void __init numa_init_array(void)
#ifdef CONFIG_NUMA_EMU
/* Numa emulation */
-#define E820_ADDR_HOLE_SIZE(start, end) \
- (e820_hole_size((start) >> PAGE_SHIFT, (end) >> PAGE_SHIFT) << \
- PAGE_SHIFT)
char *cmdline __initdata;
/*
@@ -319,7 +316,7 @@ static int __init split_nodes_equally(st
return -1;
if (num_nodes > MAX_NUMNODES)
num_nodes = MAX_NUMNODES;
- size = (max_addr - *addr - E820_ADDR_HOLE_SIZE(*addr, max_addr)) /
+ size = (max_addr - *addr - e820_hole_size(*addr, max_addr)) /
num_nodes;
/*
* Calculate the number of big nodes that can be allocated as a result
@@ -347,7 +344,7 @@ static int __init split_nodes_equally(st
if (i == num_nodes + node_start - 1)
end = max_addr;
else
- while (end - *addr - E820_ADDR_HOLE_SIZE(*addr, end) <
+ while (end - *addr - e820_hole_size(*addr, end) <
size) {
end += FAKE_NODE_MIN_SIZE;
if (end > max_addr) {
@@ -488,7 +485,6 @@ out:
numa_init_array();
return 0;
}
-#undef E820_ADDR_HOLE_SIZE
#endif /* CONFIG_NUMA_EMU */
void __init numa_initmem_init(unsigned long start_pfn, unsigned long end_pfn)
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]
