Hello, Dimitry!
Dmitry Torokhov schrieb:
On 6/27/07, Clemens Koller <[email protected]> wrote:
drivers/usb/input/usbtouchscreen.c: usbtouch_probe - type->init()
failed, err: -19
dmc_tsc10_init() returns -ENODEV (-19) when device responds with
something other than 0x06 0x00 to the "reset" and "set rate" commands.
It would be interesting to see what your touchscreen responses are.
Yes, thank you!
I just had a look into the datasheet.
(tsc10usb_pi_e.pdf, Rev. 1.2 from November 1, 2005)
and I will need more debugging info to the dmc_tsc10_init()...
As I wrote, I am using the TSC-103 without EEPROM.
(I can add one if it's of any use.)
The PanelID is 0 (pin 3 [SEL1] is low), so it's the "first"
device on the bus.
What exact chip version and EEPROM configuration do you use?
I guess there are different firmware releases for the different
TSC-10* devices which behave... well... different. :-(
Regards,
--
Clemens Koller
__________________________________
R&D Imaging Devices
Anagramm GmbH
Rupert-Mayer-Straße 45/1
Linhof Werksgelände
D-81379 München
Tel.089-741518-50
Fax 089-741518-19
http://www.anagramm-technology.com
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]
