Re: [RFC PATCH] PCI MMCONFIG: add validation against ACPI motherboard resources

[Robert Hancock <hancockr@shaw.ca>]

Jesse Barnes wrote:
> On Tuesday, May 22, 2007 6:06 pm Robert Hancock wrote:
> > There was a big discussion about this back in 2002, in which Linus
> > wasn't overly enthused about disabling the decode during probing due
> > to risk of causing problems with some devices:
> >
> > http://lkml.org/lkml/2002/12/19/145
> >
> > In this particular case (64-bit BAR) we might be able to avoid the
> > problem by changing the order in which we probe the two halves of the
> > address, i.e. change the top half to 0xffffffff before messing with
> > the bottom half and then change it back last. That way, we end up
> > mapping it way to the top of 64-bit address space, which hopefully is
> > less likely to conflict..
>
> Fixed it (finally).  I don't think moving the 64 bit probing around 
> would make a difference, since we'd restore its original value anyway 
> before moving on to the 32 bit probe which is where I think the problem 
> is.

You couldn't just reorder the code the way it is now, you'd have to 
rearrange the way we do things for 64-bit BARs:

-write FFFFFFFF to high part of 64-bit address (we end up moving the BAR 
to 0xFFFFFFFFC0000000 for example)
-If any bits stick, we know what the size is now (more than 4GB of 
decode), so just change it back, we're done
-If not, we need to check the low part, so write FFFFFFFF to low part of 
64-bit address (BAR moves to 0xFFFFFFFFFFFFFFFF)
-Check which bits stick and calculate the address
-Change the low part of the address back (BAR moves to 0xFFFFFFFFC000000)
-Change the high part of the address back (BAR moves to the original 
0xC0000000 address)

This means that at no point do we map the BAR anywhere near the top of 
32-bit memory, so we should avoid this issue in this particular case. I 
don't think this strategy is too likely to break anything, surely less 
likely than disabling command bits. Jesse, you might want to try hacking 
up something like this and see what happens.

--
Robert Hancock      Saskatoon, SK, Canada
To email, remove "nospam" from hancockr@nospamshaw.ca
Home Page: http://www.roberthancock.com/
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/