Re: [PATCH 1/1] IBM PPC EMAC driver:improved support for PHY configuration

[Benjamin Herrenschmidt <benh@kernel.crashing.org>]

On Thu, 2007-04-26 at 16:18 -0700, Jeff Haran wrote:
> From: Jeff Haran  <jharan@brocade.com>
> 
> This patch fixes some problems I found while debugging the IBM EMAC
> driver for PPC32 systems.
> The first problem was in the function that configures the PHY for
> autonegotiation, genmii_setup_aneg(). The original code does a
> read/modify/write of the autonegotiation advertizement register (reg 4),
> followed by a read/modify/write of the control register (reg 0). While
> the original code follows the proper procedure as per reading the IEEE
> specs, what I found is that on at least one PHY model (National DP83843)
> the read of the control register comes back with the soft reset bit set
> (bit 15).

Good catch ! I've seen that behaviour in the past too. Note that sungem
has this problem too.

 .../...

> The second problem was in the function that configures the PHY for
> forced operation, genmii_setup_forced(). The original code initiates a
> software reset operation via a write of a 1 to bit 15 of the control
> register (reg 0), but then proceeds to do a second write to that same
> register without waiting until that reset bit is cleared by the PHY
> itself (which according to the IEEE specs indicates that the PHY reset
> is complete). This is a violation of how one is supposed to use this
> software reset feature of these PHYs and I believe was the cause of
> mysterious, difficult to reproduce link failures that we've observed on
> some of our systems that use this driver. The fix is to modify the
> function so that it spins waiting for the reset bit to clear after doing
> the soft reset and before doing the subsequent write. Since this
> modification, we haven't seen the mysterious link failures, though they
> were so rare its difficult to say at this point whether this was the
> cause.

This is also a bug inherited from sungem (thus my fault).

> I also added some error handling and reporting for the abnormal case
> where the reset bit never clears from the soft reset operation.
> Applied to kernel version 2.6.21.

Your patch appears to have been line wrapped by your mailer though...

Cheers,
Ben.



-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/