Re: 2.6.21-rc6-mm1 ATA HPT37x regression

["John Stoffel" <john@stoffel.org>]

>>>>> "John" == John Stoffel <john@stoffel.org> writes:

>>> > Ok, so do I need to do anything special with the next -mm release and
>>> > the next version?
>>> 
>>> Well, let Alan decide that (2Alan: and I said that HPT code is bogus :-).

Alan> Try drivers/ide/pci/hpt366 - if that works grab a dmesg and let
Alan> me know.  It means that Sergei's DPLL sync code seems to work
Alan> better than the vendor code and its time to swap it over.

John> Ok, I'll give that a whirl under 2.6.21-rc7 tonight.  I'll build them
John> in modular so I can switch around more easily.  I hope.  :]

Ok, here's the dmesg output using the hpt366 old IDE driver,
2.6.21-rc7, SMP: 

[  160.926355] HPT302: IDE controller at PCI slot 0000:03:06.0
[  160.928030] ACPI: PCI Interrupt 0000:03:06.0[A] -> GSI 18 (level, low) -> IRQ
 18
[  160.931212] HPT302: chipset revision 1
[  160.932801] HPT302: DPLL base: 66 MHz, f_CNT: 100, assuming 33 MHz PCI
[  160.941157] HPT302: using 66 MHz DPLL clock
[  160.942646] HPT302: 100% native mode on irq 18
[  160.943918]     ide2: BM-DMA at 0xe800-0xe807, BIOS settings: hde:DMA, hdf:pi
o
[  160.946636]     ide3: BM-DMA at 0xe808-0xe80f, BIOS settings: hdg:DMA, hdh:pi
o
[  160.949439] Probing IDE interface ide2...
[  161.213560] hde: WDC WD1200JB-00CRA1, ATA DISK drive
[  161.828020] ide2 at 0xecf8-0xecff,0xecf2 on irq 18
[  161.829616] Probing IDE interface ide3...
[  162.094086] hdg: WDC WD1200JB-00EVA0, ATA DISK drive
[  162.709002] ide3 at 0xece0-0xece7,0xecda on irq 18


Which looks ok to me I guess.  It found my MD disks on there and
assmebled them, eventually.  *grin*

I'll reboot and send out the corresponding ATA HPT37x driver dmesg...

John

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/