RE: AHCI - remove probing of ata2

["Paul Rolland" <rol@as2917.net>]

Hi Alan,

> You have the old driver 0n 0x1F0
> 
> 
> > PCI: Device 0000:02:00.0 not available because of resource 
> collisions
> > ahci: probe of 0000:02:00.0 failed with error -22
> > ACPI: PCI Interrupt 0000:00:1f.1[A] -> GSI 22 (level, low) -> IRQ 22
> > ata: 0x1F0 IDE port busy
> 
> And the new drivers trying to manage the same port
> 
> > CONFIG_IDE=y
> > CONFIG_BLK_DEV_IDE=y
> 
> Set those to "N" and try again

Done that, rebuilt and rebooted...
/dev/hda and /dev/hdb (old driver) are gone... 
OK, rebooting again, with a new root device as /dev/sde1...
No problem for the old IDE devices, they are now /dev/sdX.

But the Jmicron stuff is still broken though no more conflict :(

PCI: Enabling device 0000:02:00.1 (0000 -> 0001)
ACPI: PCI Interrupt 0000:02:00.1[B] -> GSI 16 (level, low) -> IRQ 16
ata7: PATA max UDMA/100 cmd 0x9C00 ctl 0x9882 bmdma 0x9400 irq 16
ata8: PATA max UDMA/100 cmd 0x9800 ctl 0x9482 bmdma 0x9408 irq 16
scsi6 : pata_jmicron
ata7.00: ATAPI, max UDMA/66
ata7.00: qc timeout (cmd 0xef)
ata7.00: failed to set xfermode (err_mask=0x4)
ata7.00: limiting speed to UDMA/44
ata7: failed to recover some devices, retrying in 5 secs
ata7.00: qc timeout (cmd 0xef)
ata7.00: failed to set xfermode (err_mask=0x4)
ata7.00: limiting speed to PIO0
ata7: failed to recover some devices, retrying in 5 secs
ata7.00: qc timeout (cmd 0xef)
ata7.00: failed to set xfermode (err_mask=0x4)
ata7.00: disabled
scsi7 : pata_jmicron
ATA: abnormal status 0x7F on port 0x9807


Also, I've seen a :

ata1: Spurious SDB FIS during NCQ issue=0x0 SAct=0x7ff8001f
FIS=004040a1:00040000

What's this ? Is it really bad or just a warning ???

Regards,
Paul


-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/