Re: SATA exceptions with 2.6.20-rc5

[Björn Steinbrink <B.Steinbrink@gmx.de>]

On 2007.01.21 23:08:11 +0100, Björn Steinbrink wrote:
> On 2007.01.21 13:58:01 -0600, Robert Hancock wrote:
> > Björn Steinbrink wrote:
> > >All kernels were bad using that approach. So back to square 1. :/
> > >
> > >Björn
> > >
> > 
> > OK guys, here's a new patch to try against 2.6.20-rc5:
> > 
> > Right now when switching between ADMA mode and legacy mode (i.e. when 
> > going from doing normal DMA reads/writes to doing a FLUSH CACHE) we just 
> > set the ADMA GO register bit appropriately and continue with no delay. 
> > It looks like in some cases the controller doesn't respond to this 
> > immediately, it takes some nanoseconds for the controller's status 
> > registers to reflect the change that was made. It's possible that if we 
> > were trying to issue commands during this time, the controller might not 
> > react properly. This patch adds some code to wait for the status 
> > register to change to the state we asked for before continuing.
> 
> I went for the "I feel lucky" route and did just add mmio reads after the
> mmio writes, posting them. Rationale being that if it is a write posting
> issue, the debug patch would/could actually hide it AFAICT.
> It's the "I feel lucky" route, because my whole "knowledge" about mmio
> and write posting originates from the few things I read up on when you
> discovered the comment about write posting in the generic ata code.

Uhm, yeah, exception occured about the time that I hit "send".

Björn
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/