Re: 2.6.19.1 failing

[Randy Dunlap <randy.dunlap@oracle.com>]

On Sat, 13 Jan 2007 03:58:19 +0100 Von Wolher wrote:

> Hi,
> 
> I just build a 2.6.19.1 vanilla kernel based on the previous config
> (make oldconfig) but for some reason it is not starting. Despite
> following the usual procedure with lilo like many times before it seems
> that lilo tries to boot it and jumps back to the menu screen.

Was your previous config 2.6.18* or 2.6.19?
If it was 2.6.18* and you are using SATA, the config symbol
names for SATA changed and you'll need set them via make *config.

Otherwise we'll probably need more info.

> But selecting the old kernel boots just fine.
> 
> Any one can advise on what could cause such behaviour beside the obvious
>  steps like did i run lilo after kernel compile, check paths ...


---
~Randy
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/