"Lu, Yinghai" <[email protected]> writes:
> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]] On Behalf Of
> [email protected]
> Sent: Tuesday, December 05, 2006 3:01 AM
>
>>+static int ehci_wait_for_port(int port)
>>+{
>>+ unsigned status;
>>+ int ret, reps;
>>+ for (reps = 0; reps >= 0; reps++) {
>>+ status = readl(&ehci_regs->status);
>>+ if (status & STS_PCD) {
>>+ ret = ehci_reset_port(port);
>>+ if (ret == 0)
>>+ return 0;
>>+ }
>>+ }
>>+ return -ENOTCONN;
>>+}
>>+
>
> What do you mean by
> + for (reps = 0; reps >= 0; reps++) {
> ?
If you will not reps is negative. Roughly it is a loop
that will timeout eventually if a usb debug cable is not present.
Putting some deliberate delays in there so I could be certain
of timing out after a second or two would probably be better, but
I don't have anything that resembles a good timer at that point.
The problem is you have to wait until the ehci notices your usb
debug cable before you reset it and get it going and that can be a
non-trivial amount of time. So the loop is 100% necessary.
So since I didn't know how many loop iterations made sense I allowed
it to loop for 2^31 times or until reps goes negative.
Eric
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]
