Re: 2.6.19-rc5 x86_64 irq 22: nobody cared

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, Nov 08, 2006 at 01:44:29PM +0100, Olivier Nicolas wrote:

> Hi,

Hi Olivier,

> 2.6.19-rc5 does not boot properly, I have tried pci=routeirq, irpoll 
> without success.
> 
> Full details (.config, dmesg, /proc/interrupts) are in 
> http://olivn.trollprod.org/2.6.19-rc5-irq.tar.gz

thanks for your report!

I might be wrong, but looking at the dmesg:
- irq 22 is the hda_intel IRQ
- the "irq 22: nobody cared" is immediately before the
  "hda_intel: No response from codec, disabling MSI..."
- in the routeirq case, the hda_intel IRQ as well as the
  IRQ in the error message change to 21

So it might be related to the hda_intel MSI check.

If this was a wrong guess, other interesting messages in the dmesg are:

<--  snip  -->

...
PCI: Using MMCONFIG at f0000000
PCI: No mmconfig possible on device 00:18
...
PCI: Setting latency timer of device 0000:00:03.0 to 64
pcie_portdrv_probe->Dev[02fd:10de] has invalid IRQ. Check vendor BIOS
assign_interrupt_mode Found MSI capability
Allocate Port Service[0000:00:03.0:pcie00]
Allocate Port Service[0000:00:03.0:pcie03]
PCI: Setting latency timer of device 0000:00:04.0 to 64
pcie_portdrv_probe->Dev[02fb:10de] has invalid IRQ. Check vendor BIOS
assign_interrupt_mode Found MSI capability
Allocate Port Service[0000:00:04.0:pcie00]
Allocate Port Service[0000:00:04.0:pcie03]
PCI: Setting latency timer of device 0000:00:12.0 to 64
pcie_portdrv_probe->Dev[0376:10de] has invalid IRQ. Check vendor BIOS
assign_interrupt_mode Found MSI capability
Allocate Port Service[0000:00:12.0:pcie00]
Allocate Port Service[0000:00:12.0:pcie03]
PCI: Setting latency timer of device 0000:00:14.0 to 64
pcie_portdrv_probe->Dev[0374:10de] has invalid IRQ. Check vendor BIOS
assign_interrupt_mode Found MSI capability
Allocate Port Service[0000:00:14.0:pcie00]
Allocate Port Service[0000:00:14.0:pcie03]
PCI: Setting latency timer of device 0000:00:16.0 to 64
pcie_portdrv_probe->Dev[0375:10de] has invalid IRQ. Check vendor BIOS
assign_interrupt_mode Found MSI capability
Allocate Port Service[0000:00:16.0:pcie00]
Allocate Port Service[0000:00:16.0:pcie03]
PCI: Setting latency timer of device 0000:00:17.0 to 64
pcie_portdrv_probe->Dev[0377:10de] has invalid IRQ. Check vendor BIOS
assign_interrupt_mode Found MSI capability
Allocate Port Service[0000:00:17.0:pcie00]
Allocate Port Service[0000:00:17.0:pcie03]
...

<--  snip  -->

> Olivier
> 
> System: ASUS M2N32-SLI, AMD64 X2 Dual Core 4600
> 
> 
> kernel 2.6.9-rc5
> 
> irq 22: nobody cared (try booting with the "irqpoll" option)
> 
> Call Trace:
>  <IRQ>  [<ffffffff80259055>] __report_bad_irq+0x35/0x90
>  [<ffffffff802592d3>] note_interrupt+0x223/0x280
>  [<ffffffff80259d41>] handle_fasteoi_irq+0xb1/0xf0
>  [<ffffffff8020b17c>] call_softirq+0x1c/0x30
>  [<ffffffff8020d1ba>] do_IRQ+0x8a/0xe0
>  [<ffffffff8020a571>] ret_from_intr+0x0/0xa
>  <EOI>
> handlers:
> [<ffffffff8807f150>] (nv_generic_interrupt+0x0/0xc0 [sata_nv])
> Disabling IRQ #22
> 
> 
>            CPU0       CPU1
>   0:        223      45540   IO-APIC-edge      timer
>   1:          1        402   IO-APIC-edge      i8042
>   6:          1          4   IO-APIC-edge      floppy
>   8:          0          0   IO-APIC-edge      rtc
>   9:          0          0   IO-APIC-fasteoi   acpi
>  12:          0        103   IO-APIC-edge      i8042
>  14:          7        140   IO-APIC-edge      ide0
>  16:          0          0   IO-APIC-fasteoi   libata
>  17:          0         10   IO-APIC-fasteoi   bttv0
>  20:          0         20   IO-APIC-fasteoi   ehci_hcd:usb1
>  21:          0          0   IO-APIC-fasteoi   libata
>  22:        214      99786   IO-APIC-fasteoi   libata, HDA Intel
>  23:         76       6230   IO-APIC-fasteoi   libata, ohci_hcd:usb2
> 308:          5       3169   PCI-MSI-edge      eth1
> 309:          0         10   PCI-MSI-edge      eth1
> 310:          0         44   PCI-MSI-edge      eth1
> 311:          1       3193   PCI-MSI-edge      eth0
> 312:          0          0   PCI-MSI-edge      eth0
> 313:          0          1   PCI-MSI-edge      eth0
> NMI:         64         68
> LOC:      45716      45691
> ERR:          0
> 
> 
> 
> kernel 2.6.19-rc5 with pci=routeirq
> 
> irq 21: nobody cared (try booting with the "irqpoll" option)
> 
> Call Trace:
>  <IRQ>  [<ffffffff80259055>] __report_bad_irq+0x35/0x90
>  [<ffffffff802592d3>] note_interrupt+0x223/0x280
>  [<ffffffff80259d41>] handle_fasteoi_irq+0xb1/0xf0
>  [<ffffffff8020b17c>] call_softirq+0x1c/0x30
>  [<ffffffff8020d1ba>] do_IRQ+0x8a/0xe0
>  [<ffffffff802092f0>] default_idle+0x0/0x50
>  [<ffffffff8020a571>] ret_from_intr+0x0/0xa
>  <EOI>  [<ffffffff80209319>] default_idle+0x29/0x50
>  [<ffffffff8020939b>] cpu_idle+0x5b/0x80
>  [<ffffffff8050039c>] start_secondary+0x50c/0x520
> 
> handlers:
> [<ffffffff880e6fd0>] (usb_hcd_irq+0x0/0x60 [usbcore])
> Disabling IRQ #21
> 
>            CPU0       CPU1
>   0:        214      24856   IO-APIC-edge      timer
>   1:          0        359   IO-APIC-edge      i8042
>   6:          0          5   IO-APIC-edge      floppy
>   8:          0          0   IO-APIC-edge      rtc
>   9:          0          0   IO-APIC-fasteoi   acpi
>  12:          0        103   IO-APIC-edge      i8042
>  14:          0        128   IO-APIC-edge      ide0
>  16:          0          0   IO-APIC-fasteoi   libata
>  17:          1          2   IO-APIC-fasteoi   bttv0
>  20:         22       6469   IO-APIC-fasteoi   libata
>  21:         11      99989   IO-APIC-fasteoi   ehci_hcd:usb2, HDA Intel
>  22:          0          1   IO-APIC-fasteoi   libata, ohci_hcd:usb1
>  23:          0          0   IO-APIC-fasteoi   libata
> 308:          8       2378   PCI-MSI-edge      eth1
> 309:          0          9   PCI-MSI-edge      eth1
> 310:          0          9   PCI-MSI-edge      eth1
> 311:          4       2401   PCI-MSI-edge      eth0
> 312:          0          0   PCI-MSI-edge      eth0
> 313:          0          1   PCI-MSI-edge      eth0
> NMI:         74         47
> LOC:      25024      24991
> ERR:          0
> 
> 
> 
> kernel 2.6.19-rc5 with irqpoll
> 
> Hang during boot
> (See screenshot in http://olivn.trollprod.org/2.6.19-rc5-irq.tar.gz)
> 
> 
> 
> kernel 2.6.18 (works without any problem)
> 
>            CPU0       CPU1
>   0:       1590     998089    IO-APIC-edge  timer
>   1:          2        657    IO-APIC-edge  i8042
>   6:          0          5    IO-APIC-edge  floppy
>   8:          0          0    IO-APIC-edge  rtc
>   9:          0          0   IO-APIC-level  acpi
>  12:        194      59353    IO-APIC-edge  i8042
>  14:         13       6381    IO-APIC-edge  ide0
>  50:          0          0   IO-APIC-level  libata
>  58:          0          0   IO-APIC-level  libata
>  66:        109     181425   IO-APIC-level  libata, nvidia
>  74:         41        963   IO-APIC-level  ehci_hcd:usb1, HDA Intel
>  82:          4          6   IO-APIC-level  bttv0
>  90:          0          0       PCI-MSI-X  eth0
>  98:          3          0       PCI-MSI-X  eth0
> 106:     212234          0       PCI-MSI-X  eth0
> 114:        532          0       PCI-MSI-X  eth1
> 122:        445          0       PCI-MSI-X  eth1
> 130:     212217          0       PCI-MSI-X  eth1
> 233:         73      23009   IO-APIC-level  libata, ohci_hcd:usb2
> NMI:         99        104
> LOC:     999684     999664
> ERR:          0
> MIS:          0
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

[Index of Archives]     [Kernel Newbies]     [Netfilter]     [Bugtraq]     [Photo]     [Stuff]     [Gimp]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Video 4 Linux]     [Linux for the blind]     [Linux Resources]
  Powered by Linux